Thanks RodPad. All I can say is two spots that I calibrated and flew from with the issues are areas I have flown many times before. The time with the FlyAway was in an open field.
I did try two different spots..both areas that I have flown before. Both times accomplishing a compass cal to make sure it was not the issue. When I had control issues on these flights, I was able to over come it with more aggressive inputs. One thing I noticed is when I increased altitude...
And put in on a leash so it can't get too far? :rolleyes: Not a great feeling watching this thing fly away with no control. I had 2 short flights before this one that had control issues with good compass calibrations. I shall do the repairs necessary to get her back in the air and accomplish a...
Wibble...I was hoping for the same thing. I switched to ATTI mode with no change.
HWCM...good thought on the controller, but this wouldn't explain the continued 'fly away' after I selected RTH.
My drone for the last two flights has had control issues. It seems to have a mind of its own. I noticed a new firmware for the drone and updated it a couple of days ago. Today was a nice day to try a flight again. I went out to an open field where I have flown before, did all my checks and...
Thanks msinger. The camera did not detach from the gimbal mount, it was the j arm that broke. I will definitely get some sort of back up to that arm for the next drone/camera. Seems like a weak point.
I have a boat and most of my flights this spring have been over water. I was nervous at first, but after reading about flying over water on this forum, I just went ahead and had some great flights...up to this past weekend. Launched off my boat and climbed to about 125' in an anchorage to get...
I feel your pain. I was angry with myself for days. I was able to purchase a 3D printer arm and new flat cable on line. There are lots of videos showing how to disassemble and reassemble the camera for the repair. Be very careful with screw placement as they are all a little bit different. Not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.