When I powered up the phantom it said there was an update that needed to be applied. I downloaded it through the app and followed the install instructions. It did install without issues. I put it away and charged the battery. When I was ready to use it again the gimbal had stoppped working.
I have a P4Pro showing up today. Is there a "best practice guide" for the initial configuration? I have found bits and pieces but I have not come across a good trusted guide to go by. Also, is there any way to run the Go app from a Surface Pro?
Thanks in advance for the help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.