Recent content by hashtlt

I am surprised to hear the backlash at DroneFly. These guys have always righted me in ALL my orders. I actually live not far from the warehouse and randomly stopped by once and the guys were great helped me with my broken parts tearing down a Phantom off the wall giving me the parts free and not...

shaky as in the flight itself not yaw not jello I feel like my flying skills are not up to par My question is what mode are most people shooting in? GPS? ATTI?

I find that with my current settings zenmuse ATTI 1080 60 wide black3+ FPV/Monitor I am still getting shaky shots? is it my horrible flying skills? or is it ATTI is no good? I thought letting the wind take it would be great but not so. I watch other videos and people are going full speed...

I use the www.pettracker.com I tape it to the top of the phantom for now... I ordered some new clips and will get it a more permanently attached. (also use it on my for tracking my dog) Works great and cheap.

I am trying to figure out how to fly without getting any of the Phantom in the shot. My question is what are settings or techniques used in getting THE BEST shots possible. Is it just skill? Narrow GoPro setting? What can you add to this thread?

Yes

So the cord from the transmitter after opening up only has a yellow and a ground. Am I assuming the red wire from the board is to stay unconnected to anything? The transmitter power is soldered to the board so where does this red VCC go? Why is there not a clear instruction on how to put this...

I assume I need to cut this black video wire tip out of transmitter cable and splice together with supplied 3 color cable then attach to upgrade board ??? Just want to make sure before I cut this. Thanks guys below are pics

well i moved the transmitter over enough ( had to cut out of the phantom plastic frame ) enough that the battery fits no problem will update with pictures of the final placement .

What do you guys think of this placement under the upgrade board, clover leaf will go through small hole to the right of blink indicator and be outside of craft. My question is do you think this will being so close to board cause any issues? heat issues from battery?

Thanks. Also it appears I have a version 1 of zenmuse based on your description of metal u bracket that holds go pro... I sure hope this one does not fail. I purchased from DroneFly great guys, actually stopped by the shop the other day and they hooked me up with a 8 pin black ribbon I damaged...

Ok thanks that makes sense. I recently upgraded with new kit and reset all parameters and was calibrating gps after 3.16 urgrade, was out of wack so been doing the dance over and over. Mike thanks for your advice. I just watched your Phantom set up video, can you list your monitor brand?

During Gps calibration "The Dance" my gimbal will turn off when I invert the Phantom for final vertical rotation. Sometimes it comes back on when leveled and sometimes I have to unplug and replug back in battery to turn gimbal back on to reset to original position (it kind of locks in upside...

Re: Cant Connect to Naza Software I was able to connect to software via a pc with windows 7 Hope this helps someone else this drove me crazy

Re: Cant Connect to Naza Software I have narrowed it down to when installing the driver Installation asks "is main controller powered up and connected to PC via USB cable?" Wizard says install failed Here is a picture of my set up. Any ideas?