Recent content by grahamgee

gawd it's early and cold and my auto correct sucked on that one Sent from my SM-G900I using Forum Fiend v1.2.7.

you will only get to 1.08 from 3.04 I recently did thus myself abd couldn't be happier with it. Havent had act issues. a slight amount of jello in a wind gust was the only issue I had. aside from that she's as agile as ever! Sent from my SM-G900I using Forum Fiend v1.2.7.

Took it out for another test today, basically a fresh unit, new shell, prop guards on, std DJI props. The Gimbal still looks like it's not centered and is slightly to the left (like you say, around 5-10deg at most) but it flew just fine. It wasn't hovering too well, but I could put that down to...

Ian im sure ive seen this but mine is still doing it with my retro back to 1.08. so im unsure as to what the issue is. is anyone able to provide some concrete flight speeds? anyone able to measure it accurately? speed gun etc? Sent from my SM-G900I using Forum Fiend v1.2.7.

To an extent I disagree. When carbon hit's something spinning that fast it just shatters and/or breaks easily. The plastic ones don't take abuse, but they have withstood much more than the carbon ones did, for me.

Re: Naza cables are ok, now flips over during take off-help No problem, I had mine apart the same day so had some fresh photos to compare. As far as the backflip goes, no idea i'm sorry :( Very Tidy! OT, but would you be able to send me photos of your install if you have any shots of the...

In Australia they're about $22 and that's for two. So if I found them for $30 a set of 4, I'd be on them right away. I'm sorry - I haven't really looked out for them that much, so your research is going to be as good as mine, I just browsed through people's experiences/opinions on here with...

Re: Naza cable connections Confirm. X1: cable 1 X2: cable 2 X3: Cable 3 Is that your iOSD mounted in the nose area of the shell? I have mine mounted underneath the phantom itself but that looks like a tidy spot!

This is going to make some of the guys that have been around a while cringe, it's been covered so many times. Stick with genuine, I've got some cheap ones literally just as a backup, but that's behind another 2 sets of genuine props. I used the carbon ones. Once. Unless I can find a decent set...

Re: What's the best version firmware to be on? Okay, unhappy with even the prospect, I've managed to downgrade my unit to 1.08 I think i'll stick with this one or 2.0 for now, see how it goes and run from there. For anyone playing at home, I'm sure it's been covered, but i'll outline my...

Re: What's the best version firmware to be on? This is horrible news for me and I'm more than disappointed. Is it just in Phantom mode or does the speed restriction go for NAZA aswell?

I guess that's what the gimbal is for! haha. Have you tried doing a full calibration? Mine was unsteady for one flight and I took it back to calibrate and it seemed to reduce the effect quite a lot, the rest of it so far I've put down to the winds gusting through where I was test-flying. I'm...

Re: What's the best version firmware to be on? darn. thanks Kelly. I've been holding off on flying for now due to compass and weather. I guess my next question/research will be reverting back to 3.02 Sent from my SM-G900I using Forum Fiend v1.2.7.

What an absolutely stunning part of the world. You've got some great shots. My only criticisms would be in some you can see your controls being a little bit sharp. Smooth those out and it'd be spot on. Thanks for sharing!

Re: What's the best version firmware to be on? What are the actual speed restrictions? in mph? I've been out shooting boats/wakeboarding with previous firmware and I was overtaking the boat easily at 21mph. This was VERY handy. With the exception of some mountain bikes or cars, I don't think...