Recent content by Gpanek

What did you replace it with? just curious.

I have P3A and after doing the last firmware upgrade, the gimbal failed to work properly. Jiggled video and slanted horizon. After doing numerous gimbal calibrations and all other recommendations, I sent to DJI. They charged me over $200 to change out the gimbal motherboard. Seems to me it...

hmmm I did the gimbal calibration a couple times and it still didnt work. Also checked IMU. Maybe I will try them all again. Seems I am the only one with this problem.

Did you ever get an answer on why the gimble didnt work after upgrade? I havent and DJI was no help. they just want me to send it in.

P3A upgraded the firmware to 1.10.009 failed then aborted because it said it was already on there. Wierd, but DJI said thats ok. Now when i fly, the horizon is at an angle and the straight down view is all jittery. I have recalibrated the gimble, twice and Imu checked, compass calibration...

video streaming was ok. the firmware update said failure, so i did it again. then it said abort, firmware is the same as update. I contacted tech support and they said if it read the latest firmware on djigo, then its ok. I asked why i never got a success txt, and they ignored that said it...

I just did the most recent update to my P3A. version 1.11.0020 Went out to give it a try and the gimble looking at horizon is slanted, and when looking down its all jiggly. Also noted the graphics on the djigo app for the gimble to do not go all the way to the top ie; straight ahead. Any...

Which Phantom did you use? Any mods? Where was this? ln USA can't go over 400' high. this is good to know, I lost connection at 5700' but had mountains in the way.

Same here. I fly over lakes, around three ft and have no problem with no changes to the normal default setups.

maybe I am missing something here, but there are 1609 meters in a mile. sounds like you were at 17,940 feet, most i have gone is 5500 ft. and it was definitly out of my view. scary.

Yes, did this with the DJI tech chat guy to verify all ok. However, for android its app is 2.8.2.

i had trouble upgrading the RC after upgrading the aircraft, so I went to DJI tech chat. the guy had me reboot, in affect, the RC and I believe reconnect the RC with the aircraft. Actually in the manual there is a section on this. Here is what i copied from the chat. It was rather difficult...

RC version is now 1.6.0 and they say that is the correct verssion for the RC. you have to have multiple hands to go thru these gyrations. amazing.

i am on chat with dji. here is what he told me to do, * Turn on the controller, and the aircraft should be off. * Press C1, C2, record and the wheel on the right side of the controller and then turn off the controller. * Don’t let go of any fingers, and turn on the controller. Then the...

the RC turns itself off after a certain amount of time being idle. battery is fine. 3/4 full/