Alright. So I've replace the ribbon wire and plugged everything back in. When i powered everything up, my gimbal moved the red led light came on. Then the new ribbon wire burned out and started smoking. I turned off power immediately. Any thoughts?
Yes I have the LED light on too. And I do not get the Gimbal dance. Its as if there is just simply no power to the gimbal motors. I did notice, however, that my ribbon cable looks to have melted, or burned up on one point of it. It smells like it was burned up. I am in the process of...
Greetings!
I am new to this forum but am in great need of assistance!
I have a Phantom vision 2+ V3. I had a, err.. Run in with a tall bamboo bush the other day and had a Crash.
The 4 pin cable that goes into the side of the gimbal (the one that clips in place) was cracked and the wires...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.