Recent content by GeorgeMoses

IMPORTANT: DO NOT ALTER THE SEQUENCE OF THESE STEPS! Switch on battery – one quick press followed by a press that lasts 4 seconds. Don’t expect to see any lights, just do this step. LEAVE IT ALONE for at least 5 minutes. Do NOT touch power button on battery – plug it into your DJI charger...

I used RapidFix. It fixed the cracks instantly and now it's stronger than ever.

IMPORTANT: DO NOT ALTER THE SEQUENCE OF THESE STEPS! Switch on battery – one quick press followed by a press that lasts 4 seconds. Don’t expect to see any lights, just do this step. LEAVE IT ALONE for at least 5 minutes. Do NOT touch power button on battery – plug it into your DJI charger...

Borrow somebody's trained monkey.

I had one battery that showed fully charged when I took off and two minutes later it said it was critically low and started to auto-land. I was afraid to use the battery for several months and used my other four. One day I had some time on my hands and took the "bad" battery and charged it up...

I used Rapid Fix on my Phantom 3. The repair is perfect.

I had the same problem with my Phantom 3 Professional. I took the memory chip out, put it in my computer and formatted it. When I put it back in the bird my problem cleared up. I had formatted the chip while in the bird many times but that did not fix the problem. Don't do a "QUICK FORMAT" do a...

It would cause no injury to the gimbal or the camera to carry the drone upside down, as long as the power is turned off.

Nice video. No flight is perfect, no matter how good you work the sticks. You can hide all the stuff that's not perfect with judicious editing before you upload. That way, everybody will assume you're a video wizard!

How did you discover this? Did you read about it somewhere? Or did you find it by mistake?

Make sure your aircraft firmware is for the Advanced and not for the Professional. The only difference between the two is the 4k camera. I crashed my P3A three years ago and sent it to Drone Nerds to have the camera replaced. They installed the 4K camera by mistake and after that it identified...

Set your "WHITE BALANCE" setting to Auto. It sounds like you may have set it to Cloudy.

Au Contraire my friend. Just yesterday my P3P flipped over on the ground with props spinning at full speed. I used the CSC to stop it. I had to hold the CSC for about 5 seconds before the engines stopped.

Just yesterday I was flying my P3P to take some photos and after launching I discovered that I had forgotten to insert the SD chip. In landing I came to close to my van and the collision flipped the drone upside down on the pavement with the propellers still spinning. The only way to shut it off...

Try replacing your USB cord. I was having that same problem and losing the video signal completely. A different cord fixed the problem.