Olroy---Great location to fly and take video!
I fly in an area something similar to that. I'm in Oregon on the side of a mountain that overlooks our small town and can see all the way across the valley to the other side. My problem is that our little valley is surrounded by cell towers in the...
I guess I just misunderstood the whole channel 32 thing. When people were talking about increased range when unlocking the other channels I assumed they meant increase flight range.
Based on N017RW's response it only affects the image transfer. So people referring to increased range I guess...
I don't know much about the channels. But, I am curious....Why would my image transmission signal cut out while my RC signal was still good (without using the 32 channel hack). Do the two signals keep switching back and forth trying to find the best channel? Do the image transmission and the...
Did the 32 channel mod. I guess I don't quite understand this. If I go into the DJI app and go to the HD section. I change the channel outside the normal ones. But is that setting for both the image transmission and the signal sent to the drone for control? Or, is there another place to...
Banderboy,
Cable cross over does not matter. They cross them over as it seems that the cables fit better, but it is not necessary. So far I've only gotten out to about 13,500 ft. I think it is because the valley is surrounded with cell towers on the higher mountains. I am going to do the...
Just finished installing mine last night. Did you do the clean install? It was nerve wracking for me, but when it was done all seemed to work out fine. Was able to get everything apart well enough that if I need to I can reinstall the original antennas without a problem.
Now I have to get...
Been flying P3A for a couple months now, using DJI GO app. From reading this forum I understand that the altitude shown in the app is the altitude in reference to the point of my take off. Is there any way to get information as to the altitude above ground level during a flight. I am starting...
Just ordered and received this tablet to use exclusively for the P3 Advanced. I have the DJI Go and Litchi on the tablet. I cannot get either one of the apps to connect to the P3.
RC is connected. Get little beep when I plug USB cable into tablet, but nothing when I open app and go to...
Thanks for your help on this. Both options seem viable. ISince I already have Dashware and the flight logs I'll try that first.
Thank you Rickochet and Tenly.
With my P2 Plus I added a device that recorded the flight telemetry on a micro SD card. Then using Dashware I imported the telemetry data and the flight video, synced the two and was able to create a final video with various telemetry data overlayed on the video. Is this possible with the P3...
My new controller (the quad is not the V3 version, just the new controller) gimbal dial stopped working. I went back into RC Assistant V. 1.2. There I can set the X1 to channel 7. Do a calibration of all sticks. Also when I move the gimbal dial I can see the slider moving. After finishing...
That did it. Thanks very much. Out of curiosity where did you find, or how did you know that information?? I tried doing a search but found nothing like that.
Thanks very much again. Now I think I'll go out and fly!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.