Recent content by ftomas

There's a thread here... About the gimbal motors get hot... And about using counterweights... Did you try to star the drone with filter on and wait some minutes (1 or 2) to see if motor get warm?

See post 691

I can't see the photos. It's just me? Can you post the results and photos of the counterweights?

I got 1200m in rural area 5.8 still fine but video was weak the last 300m. I am on CE. OEM No mods

:) i understand... before use, read the the thread.. What firmware do you have now? I have 1.06.08, and i am using magic power... but just the last few flights... last flight 1.5km, country side, no interference, video always fine

You can try this How to Update Tx-Power with Magic Power v5.0

Try to link rc and drone again... By s2 switch and by hole in the drone

Can't move the camera up and down by moving the dial next to s2?

Try to calibrate RC on app Dji GO... To see what happens..

If you have no problems... I would say stay with the firmware you have now.. About video link.. You are in Europe? If so you can try magic power v5 - see the thread about it... I use in eu the 1.0.68 with it and made 1,5 km flights

Are you sure? On specs dji states Phantom 3 Standard - Specs, FAQ, manual, video tutorials and DJI GO - DJI RC eirp fcc 20dbm and ce 16dbm I think this is for 5.8 And for live view app its 100mw that is equal to 20dbm and they don't differ ce from fcc....

disconnect the cable to the router... And try again

Land hard is very different from fall from sky... And broke gimbal... Etc

You have a wired connection on this pc too? Can that be an IP conflict?

Even in atti, if you put left stick full back it wont fall of sky.... maybe it will land hard... Its important to known if the motor stop spining or not in mid air...