Hi,
Did a test flight today could you be kind enough to check everything is in order? I noticed slight vibrations but I am hoping that is due to my poor prop condition....
Thanks,
Freddie
I think that is the problem because the 3d printed part isn't the best and the motor must keep turning (that's what can be heard in the video) also you can see when I move the motor out of position it is not as powerful, which is because it is not properly attached. Will fix and get back to you.
Hi,
I thought a screw would go there but looking at the original snapped arm there was non so I presumed it was unnecessary. Perhaps it fell out during crash?
EDIT: Found the screw, it's quite small :P. Presume that's the reason will carry on in morning!
Thank you!
Hi,
So I am having a couple of issues with my yaw and I must say that I don't really mind at the moment because 12 hours ago the camera was completely useless (I had crashed it a while back) but I am having this rather odd effect:
Does anyone know what is going on?
Hi,
So I am having a couple of issues with my yaw and I must say that I don't really mind at the moment because 12 hours ago the camera was completely useless (I had crashed it a while back) but I am having this rather odd effect:
Does anyone know what is going on?
So last week on Wednesday (09/12/2015) I was flying my drone in quite bad weather (15mph) and the wind suddenly took my drone into a tree. It stayed in the tree for about 5 seconds before falling to the ground from about 20ft. Now, upside down I thought the drone was ok but I was wrong, I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.