Re: I can't get my gimbal wheel on my new controller to work
Gimbal works great. The problem now is I can't get the thing to leave the ground.
(Firmware update completed.)
I have set, reset and reset again the control levers.
Re: I can't get my gimbal wheel on my new controller to work
I must be missing one small, obvious step that is keeping me from realizing success. I'll re-read a few threads and see what's up.
BTW, this forum is great!
Re: I can't get my gimbal wheel on my new controller to work
Gimbal works great, but now I can't get the thing to leave the ground. I have reset the gain multiple times to no effect.
It's always a thrill a minute with DJI.
Re: New 5.8GHz Remote Control (left dial, built-in Lipo batt
Multiple deletes and reinstalls. Firmware updated. Painstaking step by step by step instructions. No. Joy.
Re: New 5.8GHz Remote Control (left dial, built-in Lipo batt
OK...I've tried that approach three times with no luck.
Is this an Inspire 1 marketing drive :lol:
Re: New 5.8GHz Remote Control (left dial, built-in Lipo batt
OK. Cycled through all of that and...no joy. The camera still points down unless I spin the wheel, and then will point down again when I return the wheel to neutral position. I'm going to hit the procedures you outlined again...
I'm attempting the same repair, thanks to DDM. Unfortunately, two of the Phillips head screws are refusing to come out.
It's never easy.
Update: One hold out! I'm going back in!
Must be Loctited in. I used the right size driver, but it appears to be stripped out and still stuck in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.