I apologize, I don't get it yet. Do I understand that you used a flat screw driver to align the rotation of the gimbal/camera with the "D" looking hole, then you used the vertical set-screw to lock it in place?
I haven't fiddled with it yet, but any more thoughts, instructions, or suggestions...
Greets!
What size screwdriver did you use?
Was there any friction or slots to make sure it's perfectly lined up? I'm trying to figure out how to make it at 0 degrees true.
jryser - thank you so much for your kind reply. I had earlier read your note on my smartphone and didn't see your picture - I was headed back to ask for clarification. Thank you for the awesome picture. My drone's at home, and I'll check this tonight Do you recall offhand what kind of screw...
I have a DJI Phantom 3 Professional. Flies well, gimbal works well, but the camera is "centered" off center. By that, I mean that when it's sitting powered on and idle, the camera looks about 30 degrees to the right.
I've done an IMU calibration and several gimbal calibration, and it stays...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.