Recent content by Flykam

  1. F

    ARRIS CM2000 Brushless Gimbal for GoPro

    Happy to report I mounted the gimbal further back and with the nomojello it is a massive improvement flying hard or into the wind. Move those gimbals back out of the prop wash.
  2. F

    ARRIS CM2000 Brushless Gimbal for GoPro

    Great to hear, I still have not got around to trying out my NoMo Jello. Please post a pic or video when you can. EDIT, I have to say the NoMo Jello helps quite abit. Tighten the wires right up and bolted the gimbal underneath. I guess I got to get into the habit too of flying slow and smooth...
  3. F

    ARRIS CM2000 Brushless Gimbal for GoPro

    Okay stiffened up the gimbal now and added in Vibration PU Gel dampener between the Phantom and top plate. I basically cut some electrical power cable and slide it into each ball. Nice tight fit. Then I got some pool noodle foam and wedge in each side of the two plates. Much better now although...
  4. F

    ARRIS CM2000 Brushless Gimbal for GoPro

    Feel for those having problems getting it going. :? All I did was bolt it to the Phantom, put my GoPro3 on, give it some power and off it went. It was only a few days later I finally installed the software and had a play around. Now as for this vibration, I have stiffen up the balls and added...
  5. F

    ARRIS CM2000 Brushless Gimbal for GoPro

    After many tests, I found out that this is exactly the reason why you get shaky video in forward flight. The props are channeling the wind directly at the gimbal causing it to shake. I'm considering moving my whole gimbal back further. The problem is gone when reversing direction of the phantom...
  6. F

    ARRIS CM2000 Brushless Gimbal for GoPro

    Hi. Maybe if we move the gimbal back it might be better. I stiffened up my balls :-) too but its still there in forward flight.