Recent content by Flying Mackerel

  1. F

    How to Update Tx-Power with Magic Power v5.0

    I have found dbs gives much better range if you tilt the antenna down a bit. I think the angle that it naturally sits makes it difficult to keep the panel facing directly at the bird.
  2. F

    Forced Go App Update -Workaround

    Got a feeling this thread might become very active again soon.
  3. F

    Any expert ATTI flyers out there?

    Quadcopter 101 has a great guide for flying lower end quads, which is pretty much what you have in Atti. Quadcopter Flight School: Quadcopter Orientation Tips for Distant Flying Sent from my E6653 using PhantomPilots mobile app
  4. F

    How to Update Tx-Power with Magic Power v5.0

    In both cases you still have the 2.4ghz link, although better with magic power. The rth is initiated due to loss of the 5.8ghz control signal which isn't affected by magic power. At that range you need to ensure the antenna are pointed in exactly the right direction, a slight change can give...
  5. F

    Your Experiences with DBS Itelite Antenna + Magic Power 5.3

    The firmware version I have is 1.5.7. Not got round to updating yet to 1.7, but others on here rate it. Sent from my E6653 using PhantomPilots mobile app
  6. F

    Your Experiences with DBS Itelite Antenna + Magic Power 5.3

    I'm on 1.5 and magic 5.1 and DBS. It is awesome, have been to the limit of my vision which is 900m and still had strong signal on both frequencies. Have used the recommended 24dbm, but avoided channel 13 as I think some phones don't like it. Perhaps it is a European market thing. Will do the...
  7. F

    Drone at 11,000 feet?

    The Standard specs of 5m/s climb and 3m/s decent would mean a 29+ minute round trip to that altitude if you ignore the 500m ceiling. Sent from my E6653 using PhantomPilots mobile app
  8. F

    How to Update Tx-Power with Magic Power v5.0

    About 32 minutes from posting this [emoji2]
  9. F

    Standard firmware

    This was by far the biggest news story to come out yesterday. Sent from my E6653 using PhantomPilots mobile app
  10. F

    Holy Crap ! Now RC signal not working

    Are you still able to control the camera? There are two options for creating relink, either using DJI GO app, or left hand down on the gimbal wheel and toggle S2 switch. I have found on occasion I have had to do both procedures in order to fully relink. Matt Sent from my iPad using PhantomPilots