the first part is a bit to long, i lose my focus.... i like the music, the environment is beautiful, the footage calm. sometimes i see the props, it is distracting me.... where is it? i'm not familiar with the terms VA and TN (Tenesee?) send in more footage.... i would love to see it
okay. I will try a better charger... still have some chargers somewhere... The original charger doesn't display anything accept a red and green led. thanks for the help.
so, today I gave it another try. Voltage to start with was 12.5. I flew almost 5 minutes, so that was an improvement. I flew very carefully, no extremes. Then the red light started flashing. In the software I did set the failsafe to 10.8 and 10.5 volt. When I came home I measured the voltage...
i did change that, but from 11.7 down to 11.5......
or did I read it wrong :oops: :oops: :oops:
I'm changing it now to the suggested 10.6 and 10.7...see what happens than.
thanks
just steady flying, it's not my first heli but I don't want to make a false start ;)
Just a gopro underneath... also did some flying without the gopro, same story.
no abnormal heat so I think it's the lipo or the charger. Ordered some new ones but there in backorder at the moment.....
I try...
a couple of hours, till the led was green on the charger. Even over night.... And at first I used 3 A but than the voltage would not go beyond 11.5 Volt. So I did switch to 1 A. Now it's charging tull 12.5 volt. Failsave is at 11.5 volt, momentarily.
Hi,
my new phantom only flys for about 2 minutes, than the red flashing starts. Lipo charched till 12.5 V. After flying is still is 11,5 or even more....
What do you reacon? What is the first fail-save-voltage I can use ? And the second?
thanks for any tips.
Flip
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.