I lost video signal before it went down, so I wasn't sure what the circumstances were. After a few minutes I went into FS and waited a few more minutes. After a few minutes we set out to recover it. Didn't want to kill it in mid air, but the damage was already done.
I just had my first crash with a Phantom 2. While flying over a field the Phantom made a sudden move and headed down at an angle towards the ground. We found it in said field still powered on and attempting to dig itself a nice hole. The damage:
3 broken props
Bent gimble
vTX hanging off
Minor...
Would it be possible to purchase a 2.4GHz P2 receiver and install it into an FC40, then pair a 2.4ghz Controller to that?
P2 receiver: https://www.rcdepothobbies.com/DJI_Phan ... -rx-p2.htm
I have the same problem. I'm using the 200mw Boscam transmitter and I was only able to get ~800 meters before the signal was unusable. I'm using RHCP antenna on the transmitter and have a directional and a RHCP omni on the receiver.
Tried channels 3 and 4 which seem to have the most output power.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.