The damaged ribbon is the yaw motor ribbon. I'm thinking that when my gimbal was stuck on the table while calibrating it overheated (the whole gimbal was very, very hot) and melted its ribbon.
the second melt after my ribbon bridging job might be from a weak solder point, it may have...
Hi,
I turned on my Phantom and during the gimbal calibration it got stuck on something underneath it. I didn't notice until I picked it up and smelled burning, turned it off and let it cool down.
Long story short, after noticing I have very weak and uncentered yaw power, I got the yaw motor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.