Recent content by erikhrast

I think I found out what's wrong... TX is CH1 and RX is CH8 !!! wtf With this settings the video is not lost if I walk indoor from room to room... I must try it outside. Waiting for better weather... will let you know :)

thanks.. :)

anyone?

Mine is 2.404-2.476 GHz FPV is 5.8...

I see... where can I check remote frequency? It's original Phantom remote...

Today I fly on open area... my signal is lost after ap. 10m.. Why? :( Don't know what frequency is remote controller..

Im waiting at the moment to get better LiPo battery to supply LCD and receiver.. then I will try again.

Do you mean that differet channels has different (better) signal? Currently I have CH1 5705Mhz on both..

http://www.ebay.co.uk/itm/FPV-Video-Aud ... 1e919ffa36 this is it.. Outside is the same. Maybe this is due to battery on receiver. I connected to standard 8x AA battery. Waiting for LiPo at he moment.

Hello... OK i admit I bought low budget FPV kit from eBay. But anyway is it normal to have video noise on few meter distance??? Look video: https://vimeo.com/110567401 I still have standard anntenas. I ordered circular ones... Do you think this is the issue? Thank you for help, Erik

Hello all... I discovered today that my ground wire (black), which is connected from GoPro to transceiver is making a little noise on video. If I pull it out, then it's ok. Is it OK to have only video cable connected ? Thank you for opinions... Regards, Erik

Maybe is 20%, don't know this exactly. I always fly with GPS on.

Yesterday it activated on 10m distance again... But I flew past week three times and it didn't. When the red light went on, I land it manualy. There are no rules... The settings are always the same.

Hello Phantom pilots :) I hava a question regards Go-Home function. As I understand this function is activated when battery reach first low level (30%). If it's enabled in Assistant software of course :) Now.. when I fly my Phantom and the battery is drained to low level, red light starts to...