This was one of the first things I tried.
What solved the problem was replacing the camera and gimbal. I bought a P4P camera, installed it and all was good.
The P4A has no fan on the gimbal so I think at some point it just overheated. I used to keep it turned on over my desk while debugging an...
It's a problem with the camera. I got a Pro camera (4K) and replaced it. Works great and also live video is much better since the Pro camera has a higher bit rate.
Sent from my SM-G900F using PhantomPilots mobile app
In my case, sometimes it takes more than 1 switch to make it work. I've had cases where I had to switch 3 times.
However, from what I understand it is a hardware failure so probably acts a bit different for each drone.
I suspect it has to do with the gimbal main board heating up too much. In my...
Stop flying and get it repaired.
I had cracks when my drone was a month old, but not near the motor screws.
Unfortunatly, the service here in Israel is given by a DJI dealer and not by DJI. The lab glued it and it held up for more than 6 months.
After the cracks reopened they gave me a new...
I have a similar problem, only in my case sometimes I power-up and everythings fine and sometimes I don't see an image.
When the images doesn't show I reset the camera by switching between PAL and NTSC. Usually after 1-2 resets like that the image appears. Never had any problem during flight...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.