Hoooray! I figured it out, finally. I connected to the computer and checked my calibration and found that one channel (A) did not have full range of motion so it was not travelling far enough to engage. After re-calibration everything works EXCELLENT!! I know, I'm a newbie and should have done...
In GPS mode and a single green blinking light. When I activate controls to start motors, get a double blink green light, sometimes will go back to one when sticks released, sometimes wont (which I know means that the sticks are centered).
Please help, I cannot get the motors to start on my NEW FC40. They have only started three times at random in SEVERAL tries, have not even been able to start flying. Any ideas...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.