Solved. IOC was correctly set in Naza Assistant. Being within 10m was not the issue. Turns out that I hadn't correctly activated Course Lock by cycling Switch 2 by moving from the center course lock position upwards to off and then back to the center Course Lock position. Immediately saw the...
When copter facing away from me, right stick moves copter to my right. When copter faces towards me, right stick moves copter to my left. This says Course Lock not working. However, I need to confirm answer to your point about 10m distance from me. This could be it; I'll check.
Harry, yes I do. The quick check I do is confirm control with copter pointed away, then rotate 180 degrees and test stick movements. Course lock is very different if on vs off.
I had a slightly different problem. The OSX Naza assistant software worked fine and loading the new firmware went well. However, I haven't figured out how to import the correct parameters for my FC40, as the available parameters on the DJI website are only windows. As a result I am flying...
I had the same problem setting up a Phantom FC40 on a mac running mavericks. While I'm new at all of this and you may already know this, but I discovered I couldn't connect the mac to the Phantom unless I had the transmitter powered up as well as the phantom before opening up the software.
I am a new Phantom FC40 owner with 6 flights under my belt. Naza-M V2 4.02 loaded; IOC programmed to follow Switch 2 settings according to instructions with positions of off, course lock and home lock. All flight performance is as expected (gps, atto, fail safe return to home, etc) except I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.