Re: Setting up the Futaba T8FGS with the P2
Simular to the 8J however sliding out the entire gimbal was a pain. I agree slide it under instead of removing the entire gimbal. There is a circuit board on the outside of the gimbal that I found was a pain to get out and back in.
Re: Setting up the Futaba T8FGS with the P2
P-2 Gopro zinmuse gimbal setup found on these pages puts out one awesone machine. Gret woork guys !!! on the TF8fg flies solid as a rock.
I tried carbon even the T-Motor 80.00 props on both the P1 and P2 back to the P2 Stock Props on both. They just fly better with the P2 props in my opnion. I also went back to stock motors after trying the T-Motors (189.00) was not impressed with them either. Seems like DJI did their homework. I...
May want to check on transmit power. I looked prior to buying mine and don't exactly remember numbers but felt I was far below the output numbers. May be wrong but couldn't find a lot of black and white rules. Seemed the more I read the more confusing it was.
Re: Setting up the Futaba T8FGS with the P2
The Airplane version T8FGS. I have been Spektrum for quite a while but I'll have to say I really like this Radio. It comes with the ratchet throttle. I call Hobby Services and they sent the throttle centering spring assembly at no cost I had it in 2...
Re: Setting up the Futaba T8FGS with the P2
That worked thanks again. Now hopefully just one more ? Can't seem to limit travel up would like to stop zenmuse before props can be seen. I can limit end points on down but can't seem to limit travel up.
Re: Setting up the Futaba T8FGS with the P2
Put the centering spring in yesterday. Felt like I was doing Neurosurgery. Sweating by the end of the operation but the radio pulled through just a little slow to respond afterwards but doing fine now lol. Wonder if there is way to smooth the slide...
Re: Setting up the Futaba T8FGS with the P2
Playing with the tilt thanks for all the work and info. Does the SB switch stay in the up to begin with ? still trying to figure the movement out. Thanks Again
Re: Setting up the Futaba T8FGS with the P2
Great setup I did have to do the S.BUS Servo Channel Setting. Very simple plug short plug into the receiver blins red then green thats it turn it off and you're all set. Have the self centering spring enroute. As stated in the setup add a little flat...
Re: Setting up the Futaba T8FGS with the P2
couple quick questions in the 14SG receiver install it shows changing the receiver to make ch8 s-bus. Do you have to do anything on the 8FFG R6208SB receiver.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.