i have a v2+. I have installed a new ribbon cable and now the camera shakes at power on and never stabilizes. i have adjusted the rear shaft and tried the side shaft in both positions available. other ideas?
Exactly what I was looking for\needed. Thanks. Unit is in and online and I enjoyed a day of flying today with the North Texas Drone Users Group.
Regards,
David
I do not have the original QR code as I purchased the Phantom used. I do have a new QR code with the new Wi-Fi module. I am not clear by what you mean by "tick the top right". For clarity, when I say Bind, I am pressing the button on the bottom of the Phantom and then turning on the receiver. Is...
Hi All,
I have the same issue with video feed. After doing all of the suggested fixes and checks, I finally bought a new Wi-Fi unit from HeliPal. It arrived and I installed it. I fired up the unit and am not even getting a wifi connection from the unit. I put the old unit back in and it works...
Thanks RoyVA, I have done all of that, found other good info on the mod. You are correct, I had to change my controller setting from Basic to upgraded and recalibrate.
David
Hi all,
I just installed the tilt lever on my V2+, calibrated the X1 channel and tested. All was working very well until I fired up the DJI Vision app on my cell phone. As soon as Wi-Fi connects from the phone to the Phantom, the tilt lever stops working. The gimble controls in the app still...
So you are suggesting this is heat related? Make sense as I usually get video on battery one and then no more. Haven't heard of the Artic Silver Mod. Will look into that also.
Thanks,
Dsipp
Thanks RoyVA,
Those are the first things I checked accept the BT. It is off though so not involved. I went flying last night and the battery on my android was dead so I took my daughters iPhone 6. Full video on battery #1. On battery #2 and #3, I had no video but a frozen picture on screen and...
My P2v+ recently and randomly has stopped sending video feed to the cell phone (Android). I do still record video to the SD card with no issues. I did recently have a rough landing. I have done a visual inspection and checked as many connections as I can see from the outside.
Since the unit is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.