Recent content by dronesnaps

For some reason I can't get into my dji go app. It keeps crashing. Sometimes when I'm not even in the app a message will pop up saying it crashed. Anyone else ever have this issue? I uninstalled and reinstalled but same error.

What program do you use for your way points you saved

Think the song is off of badmotorfinger. My buddy put the video together. Ya luckily the neighbor was with us so no big deal on that.

Anyone else have a little fun on this 4th with fireworks and drones?

bump

Fixed the bird, new ribbon and put it back together. Gimbal looked good, went through calibration and took it up. Horizon started to tilt after a little bit. A jello effect seems to be going on too. No ND filter, I know that will help the jello sometimes. Do you guys think the problem is...

Got her in the air. Flying good. Still some sort of issue. Gimbal calibrated correctly, horizon looked good. Then after a couple minutes the horizon started to slant and the gimbal motor overloaded and then it was very slanted. Brought her down, did a gimbal calibration and all looked good...

Guys yall diagnosed the problem correctly. I think I need a new screw though because it seems stripped to much to tighten down. Any idea on the size of the allen screw?

Thanks Oso! Much appreciated. Until then I will take it back apart and see if I can get it flat on there.

Are there any videos or further explanation on how this should be done. I think you are talking about the one screw that is an allen screw (is that the correct one?) what is the ideal placement.

<iframe width="420" height="315" src="" frameborder="0" allowfullscreen></iframe>

I have installed a new ribbon and after putting everything back together all looks good. Problem is when the gimbal comes on it stays facing slightly to the right and does a little tick and repeats it like it is stuck. When powered down the gimbal moves freely and doesn't have an obstruction...

Sounds good. Is it a certain loctite. Seems like I remember reading somewhere to use red or green...not sure if that is correct or not?

This sounds great Raceman! Thanks a bunch for the info. Once I get the ribbon I will get on it. I will let this thread know how it goes!

Anyone seen a video of someone using loctite around the ring and motor?