I have tried to take off using the app. I just learned about the RC sticks method but am unable to connect the two to even try this method of flying.
with the gimbal connected the update would always fail. not sure what else to try to fix the gimbal. new ribbon cable that was torn didnt fix...
So with the gimbal attached all wires going to it look good as ive said. nothing looks out of place.
when plugged in the drone and controller will connect no problem. only problem is when i try to take off it does nothing. and gimbal is unresponsive. no video and doesnt even seem like its...
Phantom-Paul
I have tried that the controller just beeps non stop and will not connect to the drone. The red light is blinking on the underside of the drone where you push the button to link. But when the gimbal is unplugged it won't connect. I'm not sure why. I've tried this concept multiple...
I've checked the wires and they look good. I haven't seen under the top of the drone yet to see what they look like on the other side yet but the side that connects to the gimbal looks good. All connections on the ribbon cable are secure and look good as well.
So if it is transmitted through...
took the gimbal off unplugged and when i get to the go app with drone and controller on, the lights are red on controller and the connection light on the drone is green. the app above the camera button say remote controller connected. connect your aircraft. can not get the two to connect and...
ya this thing has stumped me. ive been messing with this and trying to figure out what is going on. Ill be taking the top off the drone tomorrow and looking to see if any connections in there are messed up as well.
the weird thing is that i got it to fly once and then nothing sense then.
it wont link with the gimbal disconnected. just one of my issues.. I try to link the controller and it just keeps searching but without the gimbal connected it will not connect for some reason. ive been beating my head over this for a few weeks now.
On the controller if the gimbal is plugged in with the grey multi wire connector the drone will connect to the controller and be green and connect to the Go App but will not fly still and the gimbal is dead, will not move or show video even after the new ribbon cable was installed.
The grey and...
So I've been trying to find some help but can't seem to find the issue I am having.
I got a P3S from a family member. I was crashed and the gimbal stopped working. I did some troubleshooting and found the ribbon cable had been torn. I replaced the cable and now when everything is plugged back...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.