It amazes me how little personal responsibility/liability people have. Did you call Microsoft or apple the last time your computer froze? Did you call AT&T when your phone froze?
Guys - all this crap that it is someone else's fault is ridiculous!!
-It is an expensive electronic TOY.
-It...
I have searched, but have not found any info on this so I'm down to asking. Any help would be much appreciated.
I am down to one last little issue tuning my gimbal. I have a slight droop (facing camera left hangs down a few degrees) in roll when centered and flying. I can't figure out how to...
If you have anything attached to the bottom of the P2, then pull the battery out and see if you can see a screw protruding into the battery compartment. It doesn't take much to have it interfere with the battery.
You should look into balancing both your motors and your props. I have done both on my Phantom 2. I am using the GoodLuckBuy gimbal. It has made a big difference in the footage that is coming straight off the GoPro.
Ultimately, the best fix is in post production using Warp Stabilizer in...
Re: P2NV screw layout same then P1?
I recently purchased on of the carbon Gopro mounts like this one from China/Ebay. The screw holes did not match up to the holes on the new Phantom 2. I drilled new ones and it worked fine. Only other issue I had was that the bolts provided are too long...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.