Recent content by drakman

Finally I managed to make it work thanks to your help. I think that the trick was the fixed power. I am not sure but it works with these settings. First I made a factory reset then I reboot the AC and RC and after that I enabled telnet and I choose fixed power not limit. All now is OK. Icarus...

Thanks for your reply. The telnet was enabled. I revert back to factory defaults because I was scarry with the warning messages from Icarus..

I checked it right now but the patch cannot be applied on AC. Only on RC. Any idea? Thanks

I read that it works with new firmware 1.9.2.0. Is it confirmed that works? If yes, I have to revert back to default settings in Icarus app before the upgrade or it is not necessary? Thanks.

You have to do a rollback at previews DJI versions that worked with Google maps. Unfortunately their latest version 3.1 doesn't support Google maps and uses here maps. Here you will find all previews version of DJI Go app for Android phones and tablets. Scroll down the page and voila.. DJI GO...

I asked the creator of Icarus about the Tx power settings and below I quote their reply : Dear Mr. xxxx, thank you very much for your kind remarks. Concerning the power setting, we do consider 27 dBm a rather safe setting. This appears to be the DJI value used for FCC region so it should be...

Thanks!

@wmcvey I am also confused about the tx power settings. I am on CE mode and I use 20dbm on both RC/AC because I am afraid to go in higher values. You mean 27dbm for both RC/AC or something else? Thank you. Edit : Sorry Now I see 7 post above you mentioned that 27dbm mode is both for RC/AC

I am a little bit confused about the transmission power I have to use. You Guys what setting on transmission power in icarus app use? I have set both RC/AC at 20dbm because I am afraid to go straight to 27dbm.

The Strong interference warning messages appears also to me but I have only test the bird inside my house at this moment and not outside. I think it is normal inside the house because there are a lot of wifi signals around my area but I cannot remember before the last update such behaviour...

@cekabu look here for further details about the new firmware. 1.07.0090 FW is now official

Hi Johnny71, Check the antenna cables inside your remote control if it is in place otherwise send the bird for service.

Nice solentlife. My only concern now is if the 27dbm settings on both RC/AC is safe for the equipment or maybe stay at lower transmission power for example 20dbm on both RC/AC for safety reasons.. I have a handmade windsurfer antenna and nothing else and easily go 600-700 meters before the mod.

I always use it during transportation.

@dadum01 Nice to hear that you solve your problems with the new firmware. What version you had before?