Recent content by Dragon99

No replacing the potentiometer on the roll axis board fixed my problem which was gimbal acting crazy at start-up (as shown in the video). I was already on firmware 1.8. This potentiometer is in the gimbal not in the Phantom.

Yes I could manage to fix it. It was not related to the upgrade of the firmware to 1.8. It was a hardware issue. I bought a defect gimbal on eBay and switched the potentiometer on the (roll axis) board of the crazy gimbal.

Does anybody know a 3rd party tool I coud use to dump the IMU software of the good gimbal and then force upload it to the wrong gimbal? No luck with DJI official software.

Hi Jason, Thanks for your help. AFAIK the P2 does not require an external GCU because it is built-in already. I connect the H3-2D to an external GCU only when I want to power it without the P2. In this case I try to downgrade the IMU firmware using the Zenmuse Assistant software instead of the...

Hi everyone. I have an issue with a Zenmuse H3-2D. As soon as it gets powered it starts acting crazy. Really crazy. Basically it starts shaking violently, up and down, for a few seconds. After a few seconds, it calms down then it does it again. There is also no balance. See this quite similar...

This is my first message on this board so hi everyone! I recently received a second hand P1. It was working fine until TX could no longer bind with RX (symptom : led on P1 constantly flashing yellow). I opened the remote and noticed the antenna wire was broken :( How can I fix this? It's...