Checked all of that. Replaced the grey ribbon cable from the interference board to the gimbal. Removed the interference board from the equation and plugged straight into the board. Still no video doing it both ways. Replaced the USB connector on the gimbal. No change. Checked the black ribbon...
Checked the camera/monitor and made sure both were NTSC. I also checked that the transmitter channel was the channel selected on the monitor. I toggled between several different channels to make sure it wasn't just interference.
Have any suggestions on where to get the cables? I also am...
I bought a Phantom 2 V2 with an H3-3D gimbal. Found a pretty good priced "NEW" Hero 3. Bought the ImmersionRC 600mW 5.8 Ghz transmitter, plug & play cable, and RC732 5.8 Ghz 32 channel receiver. Plugged everything up like I have seen on countless videos and get nothing! It looks like the...
I bought a Phantom 2 V2 with an H3-3D gimbal. Found a pretty good priced "NEW" Hero 3. Bought the ImmersionRC 600mW 5.8 Ghz transmitter, plug & play cable, and RC732 5.8 Ghz 32 channel receiver. Plugged everything up like I have seen on countless videos and get nothing! It looks like the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.