Recent content by djbacha

  1. D

    Crash on the beach - why?

    I already tried to open up motors like on this video: but I didn't managed to press out a shaft inside a motor. Guy on a video is using a press. Do You have any tips how to do it without it ? (it's stuck inside very hard).
  2. D

    Crash on the beach - why?

    Thanks for all replies! Thanks LuvMyTJ for warm welcome! As jason said direct reason of the crash was my reaction to unexpected behaviour of my craft. I'm just thinking why it happened. Maybe indeed there was stronger wind + rotor wash at such low level. Anyway.... some sand got into the motors...
  3. D

    Crash on the beach - why?

    Hi. Please help me figure out what happend. I was flying near the beach. Before starting to fly over the water I did some rapid turns, fast forward/backward etc. Drone was acting normal so I decided to record that nice cliff and when I finished and started to descend suddenly my P2 started to...
  4. D

    Short flight time - too much power comsumption?

    Yes that's what I wanted to check ;).
  5. D

    Short flight time - too much power comsumption?

    Ok, thanks for reply. I was thinking about changing my Boscam TX to Immersion RC 600 mW. That might help a little. Another question : is it any way to test motors condition? when is a good moment to replace them? once my Phantom just felt from the sky during turning. I have sent it to DJI but...
  6. D

    Short flight time - too much power comsumption?

    Hi again. So I did some more tests to make it more reliable : - My phantom 2 with Boscam Tunderbolt TS5830 1000 mW + cloverleaf antenna + GoPro 4 silver + GoPro mount+ ND filter + propellers weight is exactly 1237g (photo attached) - GoPro is not charged by P2 during flight - P2 flight time with...
  7. D

    Short flight time - too much power comsumption?

    Yes, that's exactly what i meant. I checked power consumption here (attachement) - but this is not my actual statistics, I downloaded it from Internet. First check was with Boscam attached second without Boscam (motors disabled, Phantom just enabled lying on a flat surface). About GoPro... I...
  8. D

    Short flight time - too much power comsumption?

    Thank You for Your reply! From where did You get this power consumption estimation? I did a test and I checked current usage (in Phantom Assistant Software) with and without fpv attached. With FPV on it was around -1400mA and without -400mA (voltage was the same in both situations ~12A) - so...
  9. D

    Short flight time - too much power comsumption?

    Hello. I own Phantom 2 v2 with fpv attached (Boscam Tunderbolt TS5830 1000 mW) and I have a problem with short flight time < 18min. There is no gimbal attached - just simple mount for GoPro camera. Is it Boscam Tx taking so much energy or it might be something different? Battery is new (97%...