Recent content by Divyan34

Version is 1.1.1 The default setting have been applied and the tx and motor orientation settings have been switched back to normal. The phantom doesn't start, the motor only pulses like there is an error. For some reason I cant log into the Naza software either it might be down.

The compass isn't really the problem right now, the problem is that motor #3 is on when the others are not. The motor even tries to move while plugged in to the comp. Is it possible to roll back the firmware? This only happened after I upgraded to the new firmware. is it possible the esc could...

So everything was going good, The compass was a bit screwed up and so i decided to plug it in and run an advanced calibration. I seen there was an update so I updated the phantom and now this is what is happening. Nothing inside is broken or disconnected. the motor spins freely when I spin it...