I sent the unit back to the retailer for an exchange providing the information to back up the claim that it was faulty from the manufacturer. When they sent me a new one I decided to use a volt meter to tone test the wire leads and sure enough, the power and ground were reverse on the 8-pin...
OK, So I tried this also but I can't seem to find the program that guy used to update his RC with. Should I be able to do this with NAZA assistant? I tried that but nothing happens. Searching DJI's website turned up nothing for a program called RC assistant or Phantom RC. I do admit, I see to...
Wow thanks that is very helpful! I pulled the sheathing back on the harness. The red battery lead wire is soldered to the black and yellow wires which appears to the the ground wires on that diagram? It would appear that the power and ground wires were reversed based on that diagram. Does that...
That would be a great help! I took the harness apart and (I could be wrong but) it appears the power and ground leads are reversed from the factory? I haven't been able to confirm the proper wiring pin out configuration though
Hello All!
Well, I hate for my first post on the forum to be a problem but I'm hoping a wiring wizard could help me figure out what went dreadfully wrong with my AVL58 video transmitter installation.
I have a Phantom V1.1 with Zenmuse gimbal and Naza PMU V2. I hard wired the power and ground...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.