I am not having a ton of fun with this thing i am alway worried it will crash. My first flight I flew for about 12 minutes maybe more I had it close and was waiting for the red lights before landing just to see how long it would fly. One blink of the red lights then it when into auto landing...
I asked this in FPV but thought I would try here and see if I get a response...
I picked up a Fatshark predator set with immersion exOSD .. i cant figure out one part
1. Fat shark Power filter 4v its has a TX , 2s 3s 4s.. what do i do with this ?
2. on the ezOSD there are two lines i do not...
I picked up a set of FS predators and a ezOSSD from immersion. What i cant figure out is the wiring,
On the Immersion OSSD there is a board that says current sensor. I am not sure what it does, I have every thing plugged in occurring to the diagram except for the two plugs coming off the back...
I am trying to test my FPV before i put it on the p2
Does anyone have a wiring chart for a the following
ts351
RC 802
TFt color monitor - i have power to the monitor now it has two yellow jacks and a green wire that i am not sure which is the video.
I also have a plug for the video from...
Glad I read this thread. ! I just got my phantom and I have had several of these landings. Seems to come when under ful power depending on the battery. Seems to go into critical landing mode. Yesterday I was flying shooting video of a bridge over water at one point it seemed sluggish so I...
I have an used phantom 2 flown it a couple times :
1. first flight after about 13 minutes total time after turning it on I was watching it just a few feet above the red light blinked once then it went into auto land mode. I was able to catch it before it hit the fence.
2. Yesterday I was...
I guess i should have said this first
I have an RC 805 receiver a ts 351 transmitter
tft monitor its one of the headrest monitors..
I know this is not the best gear in the world but i wanted to try out something before i invested in $$$$$
to be clear i know who to hook up the...
I know this sounds silly to ask but how or what is the best way to power my monitor and receiver , I plan to tie into the phantoms battery for the transmitter but how to power the receiver ?
I believe if you get to critical battery and it goes into auto land you cant switch off GPS mode and control left right ect .. you just cannot go up... if that makes sense .. i had a bad battery and it would go into critical battery landing at two lights if I tried to fly up. when I switched...
In my search to fix my gimbal i ran across a video ended up talking to the person who made the video he then made a video to help those of us using Mac computers ..
https://www.youtube.com/watch?v=5Vzicbqa6dY
really nice video please share explains a lot !
Just to end this might as well share what I learned ..
1. you can fix the lean in some cases by pushing the button on the board once waiting for the Gimbal to go limp holding it in place for a few seconds it will restart and now be in the place it was held.
2. Pitch... i could not fix the...
well being that I am near san Jose I would say in the heart of silicon valley there has to be as much interference as anyplace else except a military base or a navy yard ...
I am looking for get FPV for my P2
I want the second camera system because I do not thru the cheap gimbal. Plus i can use it on another kit.
http://www.hobbyking.com/hobbyking/stor ... gQodYLEAJA
this is the link is 250w enough range ? will it reach far enough ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.