Final update - decided to reset phone to factory settings and this cleared the fault. Reloaded all other
apps and checked to see if DJI App got corrupted again but all looks fine now even when using the
Three In Touch - so not really any the wiser but at least everything working again. Thanks...
Thanks for response - concur likely corrupted DJI App. Tried all you suggested short of factory reset on phone alas no joy. My suspicion is turning to the "Three in touch" app which I installed owing to a poor mobile signal
at home - the app re-routes all calls & SMS via my home Wifi router...
Hi all, was unable to fly today because my DJI Vision App started acting strangely. I haven't flown
since July 2018 and all was fine then. I am using a Galaxy S5 & when I start the app all looks
good - I get a green light to show I'm connected to the drone BUT when I try and access any
of the...
Try hooking up to the
PC assistant & switching on the RC. Then go to the Basic tab and the
RC drop down tab. Click on the X1 Recalibrate button and wiggle the thumb
wheel on top LHS of RC - you should see the graphic above centralise.
Hope that helps - it worked for me.
I have the same problem out of the box. Its fine in ATTI mode so don't think its my
motors or compass. Mine shipped with firmware V3.09 but I upgraded to V3.12
before my first flight - is there any way of going back?? Have popped the lid &
checked the NAZAM module - its perfectly level & very...
Hi Dave, do be aware that you can't connect both the RC & the quad simultaneously to
your PC assistance. The way to do it is connect the quad to the PC assistant and then
switch the RC unit on. The RC & quad will then talk to each other via their own transmitters.
Hope this helps.
Thanks for the response - I noticed other people were getting warm battery
alerts but I did mine about an hour after flying & no problem there. I even
tried inserting sheets of paper under the opposite legs to the drift which
did seem to change the direction of the drift but didn't solve it -...
Hi!
Have just started flying my brand new PV2+ & discovered its plagued with the dreaded
drifting whilst trying to yaw. Have flown it 10 times now over the last three days in
everything from a 15mph gusty wind to dead calm conditions but the drifting occurs
in all conditions and can be as much...
Yes I had this problem yesterday - accidently recalibrated thumbwheel on top
LHS of RC whilst switching to NAZAM mode. I fixed it by hooking up to the
PC assistant & switching on the RC. Then went to the Basic tab and the
RC drop down tab. Click on the X1 Recalibrate button and wiggle the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.