Recent content by dave21

Hi, you need to extend the gears. The twitches come from touching the ground (grass, rocks ... Etc). Please, could you post the screenshot of the settings? To be honest i am still not happy with mine. And the settings i got with my gimbal, here on the forum or sent by email from aerialfreak...

Hm. There is Angle mode for pitch so should be fine. Check again the axis orientation in Sensor. I dont have my phantom now. Try searching the previous posts with the another screenshots.

I dont have my phantom now but from what i remember you must set correct axis to be operated by 7th channel. I believe its in RC settings tab.

So today I managed to test the parabolic reflector (see two posts above). All stock, extender (RE700) under power with power bank. Low resolution 320x240. Without reflector I reached 980m. After putting reflector it went on. Reached 1200m when "Limit restriction reached" appeared :twisted...

If I correctly see you covered the holding part with alu foil too. I am sure this part has to be foil free, since it wont let the signal of the part of the antenna which is "hidden" behind it (the same effect that one might want from the reflector to desired direction. Today I have built mine...

Hey guys. Yesterday I received requested profile of BGCsimple setting from Aerialfreaks guys. I havent tried as the weather sucks though. So feel free to test it too. Its much different setting from what I received in the controller preinstalled. See attachement. I also fight with the...

So after reclamation i got the extender back and it was replaced. Guess what i got the newer re700 :-)

Sure, unless you wanna call Bobo you spotted Bigfoot from above :-)

Ah alright I was thinking you were referring to gimbal window gains since we are talking about gimbal.

Hi, I think it was mentioned here to put both pitch and roll in Phantom assistant to zero. Its worth trying. Roll gain "80" dont make any difference in hand so it has to be tested in flight. However Pitch gain "80" makes pitch unusable while the camera does not hold the level. I leave "zero"...

Do you use the lever on the back of the TX?

I guess the pot mod which you have behave more as the original upraded TX to which the software is adjusted. Since we have the lever in the back it has probably different pot and therefore it works a bit different. It would be good to have the Calibration option for the tilt.

No problem with that. Just be careful when pulling the compas through the hole in the gear. Its quite tip top.

To be clear. I followed your steps and the tilt works. But in a manner which describes Noel. And i describe it here too. I aplied hack only for investigation. With it it works as should without it work only from limit to limit not possible to stop the tilt.

Hi, I'm using lever as well and I have the same problem. After I run the tool hack the tilt behaves as it should. Once I power cycle its gone. I managed to make the X1 channel appear in assistant. When I moved the lever in assistant it moved from very right to centre only. It jumped without...