Recent content by dannyspeed

Thanks for your help. Was this something that has changed in an update or has always been there in Naza mode?

I've not flown my phantom 2 for a while so I may be a bit rusty on the up to date naza led light sequence. Basically took off and everything was fine. Then I noticed when I went in a forward/backward direction the green leds would flash twice rather than the steady once, when havering they...

Re: What's the best version firmware to be on? So is there anyway to downgrade from 3.04? I'm not liking the speed restrictions at all.

Not happy about that at all! If dji made this clear I would not have upgraded the software. Just last week I was getting some nice shots running along side some jet skis. I doubt if I'd be able to keep up with them now. Anyway of downgrading?

Anyway of changing that?

Flying today in very little wind and the phantom didn't seem as fast as normal. The speed info on my fpv was showing 6-7 m/s at max throttle. I've seen these speeds previously at 10-12m/s. Has the recent update slowed the phantoms down at all?

Ive just got 1600 meters with a 25mw immersion tx and black pearl monitor with spironets and spironet patch on bp. I have tx pointing out the side and down (compass side) I use channel 7 on the transmitter and use f band channel 7 on the bp. Not sure why the immersion 600mw tx is getting poorer...

@ irishSights do you get much snowing or static on screen within the 1km range? Sent from my GT-N5110 using Tapatalk

Sold Sent from my GT-N5110 using Tapatalk

Anyone had any luck with this setup? Sent from my GT-N5110 using Tapatalk

Be reading this post with great interest. Got my fpv kit for my phantom 2 before I read all this, and it seems im getting pretty good results. I was after the immersion 600mw but was advised that the 25mw was good enough for 1km with the right antennas My setup Immersion 5.8 25mw transmitter...