Guys ..
Good news!!!! the circuit board is not damage.
only the connector. I order RP-SMA connector. But the supplier supplied me SMA connector instead without center pin. I didn't notice that (stupid me)
Finally 4~5 mm of paper clip do the works.
I flew 2600 Ft Yesterday. :)
Cheers mates!!
Jimbob,
The soldering is correct, it just looks a bit different in the photo. I solder the center wire core to the center tap.
I have tested the contiunity with muli tester meter. But the result is not good, I can fly only 300 Ft :(
I don't know why.
Another question..
Can I replace 3rd party remote control? I understand that I would have to replace receiver inside Phantom.
P2V used 7 Channel, right? I am thinking to replace 433 MHz system. So we can install UHF amplifier to extend range.
Correct me if I'm wrong.
Cheers!
Yes, the antenna socket on the board was detached from board.
I forced removed the stock antenna before removing the silicone completely.
Guys, be patient and slowly remove/clean silicone there. Otherwise you will get bad experience like I did.
I hard-wire to the board, but it seem not working...
Friends,
During modification, the small TX circuit board inside the remote controller damaged. Please advice me where I can get the replacement.
Thanks a lot.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.