Recent content by CyberVet65

Good to know that everything doesn't have to come from the internet.

Thanks. That fixed it.

Yes I did. Still not sure why the darn thing won't hook up.

I have the HiTec 5055mg servo. Virtually a perfect fit once the ears are removed. Servo tape and a little filing makes it perfect. But! The DJI connector and the servo wires have me totally at a stand still. I figure it would be better to destroy the servo connector than the DJI connector. So do...

Recieved my vision with an aftermarket gimbal. I don't like it. I eventually will reinstall the stock camera an mount. My question is" I have plugged my P2 into my PC with the USB cable. I power up the Tx, then power up the P2. I open the DJI Vision asst. 3.8... The TX is not communicating with...

How much are you asking?

How much are you asking for the X piece with the servo?

That is exactly what I am looking for. The piece with the servo inside. I have found a replacement servo but I am having a time wiring it up. How much for the piece?

As many folks have upgraded the Vision to a gimbal with 2 axis or more....I am looking for a set of stock landing gear with the servo in place. I have found a replacement micro servo but it would be nice to have a stock unit. If anyone has either the servo or the stock landing gear I will...

I received the Vision on a trade. It has a Taco RC two axis gimbal in place. I don't use the gimbal but I want to make it stock. Just learned that there is a micro servo that tilts the camera up and down.

I have a 2 axis gimbal and wish to convert back to the stock configuration. I have the mounts with the rubber anti-vibration pads in place. I can tell where the plug for the camera cable plugs in the back of the camera. But I have a harness that comes out of the P2. With three wires. I can see...

I did a bad thing. But it was a learning experience. Never unplug camera while unit is powered on. Soooo, I need a board. Are the controller boars specific to the gimbal? I ask this becuase I actually have a Vision with an aftermarket Taco RC gimbal. Works well or it did until I did the bad...

Right. Thanks. I just realized the P2 Vision doesn't have a 2 axis gimbal. It is aftermarket and I bought the P2 used. Thanks

Well I learned the hard way not to unplug the camera when powered up. Sparks and smoke leaking from valuable components.. So where can I get a control board for a P2 Vision. The replacement board are not configured like the one I removed. Assembly date on the board is 2013. Not that old it has...

Not looking to extend distance but providing a stronger signal from TX to camera.