Recent content by CUTTHEMUSIC

Exactly what I did during my last flight. I waited until I had 15% and then hovered it about 3 inches above the ground.

Thanks! While flying last night I had just switched to flying FPV and the gopro battery went dead because I forgot to charge it. The gopro literally died 5 seconds after I started looking at the fpv screen. Luckily I was able to still see the copter and was able to maintain control of it. I'm...

The problem is that once I get below 15% the motors want to automatically turn off because I have the phantom sitting on the ground.

The DJI Phantom 2 manual says "It’s recommended to charge and discharge the battery thoroughly once every 20 charge/discharge cycles. Users should discharge the battery until there is less than 8% power left or until the battery can no longer be turned on. Users should then fully recharge the...

I picked up one of the cables from getfpv and installed it tonight. I used peel and stick vinyl sheeting that my wife uses for crafting to hold the wires in place. Before securing all of the cables I checked to make sure that the gimbal could move without getting snagged by the wires. I then...

+1

My bad......it's Monday morning. ;)

Are you talking about the ribbon cable that is used to connect the Zenmuse H3-3D to the gopro camera? If so then see this link. viewtopic.php?f=26&t=22798

Re: AMA Requests YOU Send Comment to FAA Re: Their Rulemakin What exactly is everyone leaving for their comments? What I would like to say to the FAA and what I should say are two totally different things.

A new H3-3d fixed the issue. Thanks everyone.

I understand the pinouts. My question is whether or not bypassing the anti interface board will affect video quaility.

I have an immersionRC TX. Looking forward to your documentation.

I am very interested in doing this mod but have a few questions. Does doing so bypass the Anti Interface board? Does that affect video quality? I have a IOSD mini, do I splice the video signal into the cable that goes from my IOSD to my fpv hub?

Haha, I called them up and spoke to someone after waiting on hold for 15 minutes. I was surprised too after reading how awful their support was. The guy I spoke to was super nice and quickly came to the conclusion that it is most likely a gimbal issue. I'm hoping his diagnosis is correct.

I spoke to DJI today and they feel it is most likely a defective gimbal. B&H is sending me a new one so I should know for sure in the next day or two. I will post a follow up. Thank you everyone for your help.