If you hold the motor ends up close to a bright light you should be able to see a web pattern in the plastic housing. The pattern goes from the outside of the shell in towards the motors. This is the newer shell design. The old design had only a four webs supporting the motors. I hope I...
Thanks Scratch for your update on the new fw. Ive been reading about this 1.6 upadate till my eyes bled. And most update results were really bad? I am really glad to hear a positive post! Through my research i did learn that my p3a has the updated motors and shell so we'll see how the update...
This is where my dilema leads me too... Update or not update ??
i'm assuming its ok to fly as it is with this 1.5 Firmware correct?? Surely DJI wouldnt send anything that needed updates before you can even fly right? Thanks for you time..!
I purchased a P3A (have not flown it yet) and after several hours of reading i'm still extremely concerned about updating the firmware. As it stands right now out of the box App Version is 2.4.3 RC Version is 1.4.30+ Firmware Version is 1.4.10+ Can someone give me their...
I have a replacement fc40 transmitter and i thought i should calibrate it. I went into the naza software, basic tab,RC tab and under the command sticks calibration all seems good except the third one down (throttle) it is showing the slider all the way to the left and is black in color, not...
I ordered another transmitter so i can get the fc40 up in the air again. But, im not giving up on my old transmitter yet,going to try and clean and solder the connector back to the tx board. maybe upgrade the antenna and see what happens.. Thanks for everyones replies...
It made sense that it was some type of connector in order to repalce the antenna. But this stuff is so small(and covered in the white glue) I spent an hour cleaning the white glue and still couldnt see a connector.This site has been a great source of info. Thanks Ramz for your replies, they have...
I didnt realize its a coax cable...it may be the smallest coax ive ever seen! To make matters worse, I thought there would be a male/female connector at the small metal box that the coax connects to so I attempted to seperate a connector that doesnt exist. Now I have a broken silver box that...
Ok, Now that i know where the cable was supposed to go, I took a closer look and see the white glue.I could solder the wire back on the connector to make the connection again. But, is there an advantage to using the antenna/cable from ebay? The seller is also asking DBI? I'm not sure what this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.