Yep that's exactly the one that's the problem. I'll keep tweaking it.
Thanks again for your help with the first part of this, it helped a lot.
EDIT:
So ultimately I just had to get the roll sensor adjusted so that it was like it is in the photo.Now it's all working exactly as it should.
So rotating the shaft and the sensor seems to have stopped it from freaking out. Now the only weird thing it does is when it starts up, the camera is rolled at a weird angle until I manually reset the gimbal calibration.
Perhaps I have to keep adjusting the sensor and shaft?
I just replaced the flat cable for my P3S after a minor crash. Additionally, one of the gimbal motors separated, but it seems to go right back together without a problem. DJI Go just says there's a gimbal problem and I have to contact DJI.
Here's a video and a picture to help show what I'm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.