Recent content by cmturn0

Re: DJI 900mhz Datalink + CP antennas & extras - $250 shippe SOLD!

Re: DJI 900mhz Datalink + CP antennas & extras - $250 shippe Bump $250 shipped!

Re: DJI 900mhz Datalink + CP antennas & extras - $275 shippe Got a question regarding "what exactly does this do" so figured I would put up a link. http://www.rc-drones.com/DJI-900mHz-Dat ... p_204.html

Up for sale I have a DJI 900mhz Data-link. This is the REAL DEAL, this is not the same as the wimpy 2.4ghz datalink. It is much higher power that the 2.4 Data-link & because of the lower frequency it has much better object penetration and increased range. I have used this with my Phantom2...

The best trick I've found for installing bearings in anything, is heat and cold. Before you get ready to install the new bearings, put the bearings in the freezer for an hour or two, and either leave the motor coil (or whatever is receiving the bearings, this works for putting bearings in...

no need for 2 transmitters, just a video switch & 2 camera's. If you want to get real slick, tee the camera video out before the iosd and connect that to the 3rd input on the video switch. You can then select between Cam1 w/o OSD, Cam1 w/OSD, & Cam2 by flipping a 3 position switch. You'd...

based on the references to protune & 1440p res. I'm assuming this can only be done on a go-pro 3+ black?

Of the 3 Phantom's I currently have (2) are vision plus's and one is a regular vision. The front 2 ESC's on the vision make the beep, and none of them do on either of my vision plus's. The regular vision was a parts donor for a while and I swapped a front ESC from the vision to the plus and...

I have also found a marked increase in flight time and responsiveness with the CF props. What I have found is the "dancing around" behavior isn't so much caused by them being out of balance (although you should definitely balance them too) so much as not being aligned on the hub correctly and...

LOL, yeah I need that one! :D 8-)

yeah, I have gone back and changed every turn to banked in my last couple missions. I have seen it pop up a warning (seems intermittent, hasn't done it last few times) about my first turn being banked, or adaptive banked. But I never understood why, have just clicked "Ok" upload, and haven't...

I'd like to see that video, have a link?

Hmm, interesting I have not run into this problem. I will usually set the first way point as close to my takeoff spot as possible to prevent this issue you mentioned of hitting things as it climbs between way points. That being said, it will usually go straight up to the height I set on way...

You can select turn type at each way point. It defaults to stop, spin around, hover for 3 seconds, change it to adaptive bank, or bank turn to remove this stopping at each way point. You can also set the direction that Phantom is pointing at/between each way point (In the PC version anyway, I...

Short answer, sell your phantom 1 & get a Phantom2. Flight time is going to be your biggest hurdle to overcome if you stick with the phantom 1. No point in spending money on crazy long FPV range if you don't have the battery capacity/reserve to go much over 1km or two before you have to turn...