Recent content by cja844

  1. C

    Need Battery Replacement for P3 Standard Remote Controller

    I assume it is just a 3.7 volt 18650, and if the case then soldering a 26650 up to connecting wire would work just fine!
  2. C

    Question about recording.

    AZ screen recorder, it's free!
  3. C

    Cheap tablet?

    I have an older tablet that refused to work with dji, way too slow. I would say a cheaper tablet could run the app but just may be a little slower (choppy) feedback on the screen. Yeah caching is just pulling up the map in the app while connected to wifi at home and looking and zooming I...
  4. C

    Override litchi return to home

    The only way I could do it was to flip the s2 switch (?) (right side) back and forth once and that worked
  5. C

    phantom 3 4k wifi

    I use Samsung tab s2 9.7 and love it. It is lightweight, big, and fast!
  6. C

    phantom 3 4k wifi

    Not the standard or standard 4k, it is wifi connection!
  7. C

    New Member from Richmond, Virginia

    Richmond area here! Have you Flown in any good places around here yet? All the good places I know of are parks or lots of people around. Going on a river trip down the James in 2 weeks and taking the phantom, hopefully won't land it in water!
  8. C

    Chagring a P3A in the car with inverter calculation

    Ps it may be even less than that due to inverter safety shut off, I know mine cuts off when battery gets close to 12 volts
  9. C

    Chagring a P3A in the car with inverter calculation

    With a rough calculation on a regular deep cycle I would say 6-8 before battery is dead! I would not run it on actual car battery without car started just in case. And that is on a deep cycle and not just a normal car battery (would be considerably less on regular car battery). And p3a has a...
  10. C

    Homemade tablet bracket and hood!

    Nice, might have to upgrade! I want an antenna booster as well but not ready to spend another 100 or so quite yet! Is it pretty sturdy without wiggle?
  11. C

    Homemade tablet bracket and hood!

    Going to find out here soon! But hopes aren't high on the cardboard and foil.
  12. C

    Homemade tablet bracket and hood!

    Couldn't find any good, inexpensive options for a reliable, 10 inch tablet holder so created my own. Bent a zinc coated metal rod to raise tablet out of way of antennas and closer to my face, and just cardboard for now to make the hood. Zip tied it on so it can be easily removed if necessary...