Yes I did switch the wires inside to a single wire subs from the receiver to the controller. I have also checked the switches to see if they are working properly and I have not had any issues with switches
So reseting the transmitter didn't work. My last guess would be that since I updated the naza controller my transmitter may need a spring loaded throttle which it does not have. Is there anyone that could confirm that?
I'll try that but I think I did that to begin with because i switched it from traditional to S-bus. But hey I'll do it again and see what happens. Thanks for your help sir!
First thanks for the reply :)
I have contacted UAV Advertsing, he said he couldn't help me...
Trim is at 0 across the board
I have calibrated both the sticks and the the quad
I have followed the gps calibration procedure, and when finished I get the single blinking green LED indicating that...
Hey guys! So I just bought a used DJI 1 from a friend of mine. He hadn't used it in awhile so I decided to give it a good once over. These are the current features and/or upgrades. (This was all done before I bought it) A guy that advertises himself on youtube as UAV Advertising did all the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.