Recent content by ChuckMRN

I have both a P2V+ and P3P. I did not do any beta testing on the app for the P2V+, but I did purchase it once it was available. Now I fly the P2V+ almost exclusively due to the POI, Follow and GS for specific shots/planned footage. The controls are a lot more smooth with the P3P for random...

maybe a plastic tie wrap done loosely thru the clover leaf as a safety.. good luck

negative.. good luck

Before and after with two small pieces of heat shrink I started at the fat part of the plastic and just went very slow. The pins in the 90 joint come out pretty easy once you pry the ears apart. A simple cut and pry with a flat tip screw driver will get you started

I'll try to answer some of these, hopefully DronePilot can correct any misinformation.. 1) yes 2)DJI uses CAN Bus cables for many things, not sure what works with the Plus 3)With the WiFi extender on the controller turned off the 2.4Ghz GS works fine. When I was using the 2.4 I would start...

900Mhz info http://www.phantompilots.com/viewtopic.php?f=27&t=20664 1- I found it better to just purchase the CAN-BUS Module so I could use a meter and "ring out" the wires for my self 2- I used a dremel tool and a cut off wheel in a vise and took my time cutting it all off. I ran the antenna...

If you want the video on your phone, the phone will convert it for you. Place file on PC desk top (or where ever you wish), connect phone with supplied USB cord to PC and select "connect as media device" in pull down menu of phone. Drag the video file to the phone's video folder and it will...

Only if you want to use iOS. With out the Bluetooth a PC is your only option. If you get a chance to read all of the following it is very informative. Including all of the limitations with the 2.4Ghz on the Plus http://www.phantompilots.com/viewtopic.php?f=27&t=18439 If you are serious about...

1- the Internet is required to get the maps 2- yes, you can set up at home. This will cache the maps. Then missions can be edited on site if needed. 3- yes

a minute from last weekend https://www.youtube.com/watch?v=iHcq-WaM_xQ

Signature worthy :lol:

my experience is that if the waypoint is a "stop and turn" and going to a "stop and turn" it will not depart until it has gained the elevation set for the point. It will fly thru a point with out the set elevation that is set for "bank of adaptive" YMMV.. Good Luck Chuck

The 2.4 does work, but you are right it has it's issues. I used it for a while, even before the DJI App GS. Now that I have the 900Mhz I can get consistent round trips of >5600 meters with my current batteries (30 plus cycles) and the xtra weight on the bird (strobes,TAGG,900Mhz air...

If Ground Station is your thing and you don't mind using a PC, then the link below is what you need with your current platform. IMHO cheeper to run the 900Mhz than switch to another platform to run the 2.4, but if you want to use iOS then you will have to change. Good Luck...