Hey I'm looking for stock motor and esc as I have 1 of each burnt out . I believe the motor is the grey top but would like both anyhow . Also looking for dampener balls and the little clear plastic retainers and clips.
Let me know what you got
Cheers
Chris
Yah just trying to educate and there is a seaplane base in the area, the TC regs are confusing to follow at best. They look as though anything under 2 kg is exempt until you read all the way through . Just because you can afford an item doesn't mean there isn't rules regarding it's use. There's...
Not correct. You have adds in your videos they are now considered commercial as you can monitize them.
TC rules state any flight within 5 miles of a built up area require a sfoc regardless of the uav size. Built up area is anything larger then a farmstead according to TC.
You could face up...
I have a P2 non vision and I believe that's more what the GS is designed for. I would think your better off to install antenna upgrades on a vision and use the available app.
Re: 2nd Flight, Crash video
Welcome
Lots of good advice so far. I'd be tempted to pull he top off and take a look inside to make sure nothing got bumped loose. Hopefully you did a compass calibration before your first flight, I would definatley do it before the next flight . I like to power...
Esc can fail in a few different ways if 1 phase fails it will stop and jerk back and forth. Disconnect 1 of the 3 wires going to a motor and try and power it up to see. Esc can also miss a beat going out of time but makes a heck of a noise when this happens.
I would guess you had a sudden loss...
May have damaged the gps if it hit hard enough. I would be tempted to send it in and have it looked over as there could be a # of things that could cause that.
Re: Another one bites the dust -UPDATE- found it!! - Page 5
This is not the case on a 3 phase motor. Losing 1 phase still leaves 2 live which will cause the motor to essentially lock up or cog back and forth in 1 spot. If it was to completely loose power it would wind down as you said but in...
Re: Another one bites the dust -UPDATE- found it!! - Page 5
Glad you were able to recover it. It sure to a hit but I guess falling from that height would do it. I follow a tali 500 thread and it has a similar issue with esc wires. Securing them with hot glue seems to have solved the problem...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.