Recent content by Celt in Siam

Yes, pressed twice to start as normal but nothing happens. After about 6-7 seconds the switch LED flashes red. I cannot check battery condition as the P2V needs to be powered up to connect to the PC software.

When I insert a fully charged battery into the P2v it does not start up. Pressing the 'on' switch shows 4 green bars but wnen holding the 'on' switch to start up the P2v . the switch flashes red after a few seconds. I have three batteries and all act the same way. They have not been used for...

Re: Not DJI Intelligengt Battery! Thanks Geert but it seems that I have a different problem as the P2V works OK with my other batteries. Somehow, the DJI software upgrade detects what it thinks as a non OEM battery although it is a genuine DJI one supplied with the P2V.

Not DJI Intelligengt Battery! I have just upgraded to the latest s/w and f/w versions and now one of my batteries will not start the motors and an error message 'Not DJI Intelligent Battery!' when connected to the DJI Assistant. The battery concerned is the original one supplied with the Vision...

Thanks but I already had them checked out at Bird's Eye View here in CNX. They can be repaired at a cost of around 50% of a new one but with a reduction in capacity which would only give around 10 minutes up time.

My two Phantom Vision batteries were accidentally left fully charged for around two months and now will not charge at all. Is there any way to recover them. I know that they should have been stored at ~50% but hadn't planned on them being unused fro such a long time.

Just has a flight and got the usual battery warning which is set at 30%. Tried to remove the battery but it was stuck, eventually got it out and noted that it was quite hot [not unusual] but quite swollen. Checked the battery status and found that it was still at 56% and all three cells seemed...

I have downloaded the latest revisions of the DJI Vision and DJI Assistant apps to iTunes. Both apps were successfully updated to my iPad Mini but will not update to my iPhone 5 - both are running the latest iOS. When the iPhone is connected to iTunes, both apps show 'Update' in the Apps Tab but...

OK, it's time to quit messin' around with baby toys - check this out. Mine is already on back order :D http://www.flixxy.com/huge-remote-contr ... _source=nl

Neat solution! Can you please post details of the LED, power connection etc as I'm looking to do something similar

Didn't work for me... WTF????? Didn't work for me either :( Looks like it is an IOS 7 issue. I have the program on my Note 10.1 but it is way too heavy to fly with so I guess I'll have to try to use the corrupt crap on my iPhone 5 till DJI gets around to fixing it - hopefully before...

OK thanks P-U, good to know.

The DJI Vision Assistant screen says the program copyright belongs to DJI Innovations - are we going to see this unsupported now?

Just tested this on a PC, and like on a MAC it does not work. Ok, let's hope DJI/Heli-X take note and issue a fix.

More haste, less speed - just found a four pole splitter on Amazon. Now, where did I put my multimeter? Need to measure the available voltage.