Recent content by CDBettler

  1. C

    Gimbal Fan Noise

    Do you mean soldered to the board inside the gimbal? Two screws hold it on and if I get the new fan I could just use the old wires and solder them up with the new ones. I bought the drone second hand a while back, I don't think I have any warranty to worry about.
  2. C

    Gimbal Fan Noise

    Had to figure out what it was! Would you suggest replacing it myself at that point?
  3. C

    Gimbal Fan Noise

    Had my P3P recased few weeks back in NY at the DJI certified repair shop. Took a god awful long time and I don't want to send it back, but i got it back 1-2 weeks ago and haven't had a chance until today to start it up and put it in the sky again. I flew it but didn't notice any issues. When i...
  4. C

    P3P wire damage

    Another issue I just noticed is that one of the motor mount screws is rounded... Torx will not grip it. Any tips on getting that out for future reference? I've drilled out bolts before but on much larger scales.
  5. C

    P3P wire damage

    I must say working on the quad is somewhat daunting for me. I can work on my vehicles all day but when it comes to tiny parts and plastic, im not as quick with it. Is a whole shell replacement very difficult?
  6. C

    P3P wire damage

    Went to replace my bent landing gear today and got all the way to buttoning the shell back up and accidentally frayed the wire to the compass and also one antenna - should I send this out to DJI or a certified location to get fixed or can I solder these wires? Should I just bite the bullet and...