Recent content by Carlos961

hey guys, so i had my first control loss of my phantom there were signal interference in the area i was flying in and my P2 with H4-3D crashed, and the gimball lost the horizon i adjusted it as much as i can but it;s still no 100 horisontal any i dea on how to fix it???? and thanks in advance

I checked the GPS module, it's not broken it's just scratched a little bit you can barely see the scratches the new thing that's happening now is that i'm getting fast green light for 1 or 2 seconds and then it comes back to 1 green the 3 fast reds. Do you have any idea what should i do now??

you should do the calibration in the RC Assistant program the same way you do it in the phantom 2 assistant program, click calibrate and do whatever the software tells you to do with the sticks, and before clicking finish move the X1 switch several times then click finish. note that i will not...

ok done i took it apart and found the gps module seems nothing is unplugged any advice?

no i get one green followed by 3 reds as shown in the video.

S1 and S2 are both all the way up all the time i usually fly GPS with IOC off, i wait for it to initialize GPS outside of course but i did the video inside just to demonstrate what's happening. when flying in NAZA-M mode on gps and ioc off it seems like flying in atti because when i go...

hello guys, i have this problem with my phantom, i was flying i lost control of the craft no idea why then it when down very quickly it hit the floor but not really hard cz i throttled up then i landed it but it wasn't under my full control, nothing broke. I normaly fly in phantom 2 mode (in the...

i tried the steps again and it worked, thank you sooo much MR. C, i updated the description of my video with the solution too so everyone that has the same problem cam see it :)

I did that and that's what i got https://www.youtube.com/watch?v=hyHDul6SviI