Recent content by canvey1981

http://www.ebay.co.uk/itm/dji-phantom-F ... 2a42586722

Already have mine fitted. I bought mine on good old eBay.

Sound advise. I may lower the voltages by 0.1 and see how I get on.

Mine measure 100mm minus wires of course.

Specifications Length mm 104 Width mm 35 Depth mm 27 Weight (g) 201 Voltage 11.1 Cell Number 3 Discharge Rate 30C Constant Chemistry LiPo Burst Discharge 50C (8 seconds) Compatible With DJI Phantom Quadcopter Watt Hours (Wh) 32.2

Hi, I have recently set my fc4o up to run dual 2900mah Overlander batteries. I am using a Walkera G-2D gimbal, vision 2 props, extended landing gear and all else is standard. Today I got 17 minutes of flight time.... that was what I would call general flight at low high with quick turns and...

Sorry guys I just found this... Does that sound about right ???

Hi I have just set up my fc40 to run dual battery's (2900 mah 30c overlanders). Should I be looking at changing the low battery warning on the phantom or should I leave it the same ??? Many thanks Darren.

Thanks for the reply. I ending up getting one from eBay.

No problem.... I was quite shocked when I measured the distance. That was where the camera started breaking up right before it loses signal. I may have got further if I had gone a tad higher to keep line of sight but who cares that plenty far enough away for now.

I just did a 1000ft fpv flight with the 3040 setup with 7dpi directional antenna in a built up housing area. Very very happy with that. Thanks guys. Hopefully a lot more to come. This was the first flight with the antenna and I will be back out tomorrow for more.

At least I'm not the only one.... I have desoldered the joints now and I'm going to re do it and add a 7dbi directional antenna.

Ok guys I got my 3040 and soldered as pictured and in the video.... I have just taken the quad out and I am getting worse range than before. That's with it connected through the repeater to and ipad, iPhone and android tablet. All three show worse results :o what have I ballsed up. There was a...

Mine has just given up the ghost :-(. Need one ASAP. Thanks.

We'll I know nothing about networks and networking but hooking the MR3040 was very easy. I just changed the 0 to a 1 as the SSID. This forum has been all the help I needed to get it done. Thanks for the help guys